KOSOKU KCM-370NE·SC / KCM-370NE·SC 60°: three catalogued functions for precision metal cutting.
This is a function guide for the KCM-370 series. The sizing stop does not imply automatic stock feeding; scale increments are not accuracy guarantees.
The KCM-370NE·SC and KCM-370NE·SC 60° precision metal cutters combine a sizing stop, adjustable angle cutting and a double-roller chip remover. This page explains how these three features support repeat-length and angled metal cutting. For the complete machine specification, see the KOSOKU KCM-370NE·SC metal cutter product page.
The information below follows the FUJI KOSOKU catalog. A length stop is not an automatic stock feeder, and scale graduations are not a guaranteed finished-part tolerance.
The sizing device lets the operator set a reference length for repeat cuts. For the KCM-370NE·SC and SC 60° models, the catalog gives a 0–850 mm setting range and a 1 mm graduated scale for the 370 type.
This is useful when preparing multiple pieces to the same nominal length: set and secure the stop according to the machine instructions, verify the first piece, then check subsequent pieces against the required tolerance. The 850 mm figure describes the length-stop setting range, not the maximum workpiece diameter or cutting cross-section.
The two variants have different right-hand angle limits. The guide plate uses 1° scale increments to assist angle setting.
| Function | KCM-370NE·SC | KCM-370NE·SC 60° |
|---|---|---|
| Sizing stop setting range | 0–850 mm | 0–850 mm |
| Length scale | 1 mm graduations | 1 mm graduations |
| Left-hand angle limit | 45° | 45° |
| Right-hand angle limit | 45° | 60° |
| Angle scale | 1° increments | 1° increments |
| Chip removal mechanism | Double-roller system | Double-roller system |
The 60° variant extends the right-hand range; it is not a machine with 60° cutting in both directions. Before choosing a model for frames or angled joints, confirm the required angle, stock shape and the machine's cutting capacity at that angle.
The catalog describes a double-roller chip remover that clears chips from the saw teeth, helping reduce tooth clogging and maintain cutting performance. This can support blade life by keeping the teeth clear; it is not a promise of a fixed service-life increase.
The device acts at the blade. It should not be confused with an automatic chip conveyor, a dust-extraction system or an automatic feeding mechanism. Inspect and maintain it according to the machine instructions, with power isolated before cleaning or adjustment.
Actual finish, burr level, cycle time and repeatability depend on material, blade selection, stock support, clamping and operating conditions. Confirm the material grade and cross-section with FUJI rather than treating the functional ranges as universal cutting capacities.
The catalog also lists other KCM models. This page focuses on KCM-370NE·SC and KCM-370NE·SC 60°; do not transfer the 370-series length range to a different machine.
No. The documented function uses a sizing stop. This page does not specify an automatic feeder or automatic cutting cycle.
No. It is the scale graduation. Required part tolerances must be checked under the actual cutting conditions.
KCM-370NE·SC 60° extends to right 60°. The standard SC model extends to right 45°; both extend to left 45°.
It is the sizing-stop setting range. Cutting capacity for round, square or other stock must be taken from the applicable machine specification and angle setting.
Its double-roller system clears chips from the saw teeth to reduce clogging and help maintain cutting performance. It does not replace routine cleaning, guarding or maintenance.
Send the material grade, workpiece shape and dimensions, required length and tolerance, cutting angle, expected quantity, electrical supply and delivery country. Specify whether you need the standard SC model or the right-60° version.
Request KCM-370NE·SC application support and a quotation
For other equipment options, compare the FUJI KOSOKU metal cut-off machine range.
